English

News center

News center

News center
News
Technology

Tension sensor installation attention points

Author:Limit    Date:2022/10/5 22:42:39    View:123

We need to install the tension sensor before using it. If the installation method is wrong, then the impact is relatively large. What problems should we pay attention to when installing it?

Let's introduce the tension sensor installation attention points.

1, according to the description of the tension sensor range selected to determine the rated load of the sensor, tension sensor itself has the corresponding overload capacity, but in the process of installation and use should try to avoid this situation. Sometimes a short time of overload, may also cause damage to the sensor.

2. The tension sensor should be handled lightly, especially for the small capacity sensor with alloy aluminum material as an elastic body, any impact or fall caused by vibration is likely to cause a large output error.

3. Wiring according to the instructions before installation. Common wiring mode: The red is the positive pole of the power supply, connected to EXC+; the black line is the negative pole of the power supply, connected to EXC-; the green line is the positive pole of the signal, connected to SIG+; the white line is the negative pole of the signal, connected to SIG-; the blue line is the positive pole of the feedback, connected to SEN+; the yellow line is the negative pole of the feedback, connected to SEN-. Please connect cables according to the instructions for details.

4, sensor shell and the seal processing both protection cover plate, wire connectors, cannot open, cable should not be lengthened by oneself, because of the sensor cable, adjusted in the factory according to the output resistance and longer or shorter version will affect the sensor output resistance, to effect the precision of the sensor, if really do need to lengthen should be in the soldering joint, and to add moisture sealant, Adjust the resistance again to reach the factory default output resistance, 5, the cable of the sensor should be far away from the strong power line or the place with the pulse wave, which can reduce the interference source on the scene to the sensor signal output, reduce the error, improve the accuracy.

6, in the use of high precision, should make the tension sensor and instrument in preheating 30 minutes after use.

7. When purchasing the sensor as a spare part, the tension sensor should be stored in the room with dry ventilation and non-corrosive gas.

I hope you should pay more attention to the content we introduced when installing the tension sensor in the future, these contents are very big to help you. Our related products are very good, you can rest assured to buy. If you think our products have shortcomings or deficiencies, please comment and correct us.

 News center